Cirrus SR22 G3-G6 Headset Holder
Removable headset storage accessory that slides onto the front-seat grab handles. No drilling, no cutting, no adhesive, and no permanent modification of the aircraft. It holds portable headset equipment, does not replace any original Cirrus hardware, and lifts off to return the seat back to its original configuration.
Confirm your airframe
Compatible with select Cirrus SR20 and SR22 configurations, G3 through G6. G7 and G7+ use a different front-seat grab handle — contact us before ordering and we'll tell you where that stands.
Ask about my aircraft →Two headsets, out of the way
Loose headsets end up on seats, in footwells, or hanging off the yoke. This gives your portable headsets a fixed home that doesn't cost you visibility. Before each flight, verify that the holder and stowed headsets are secure and do not interfere with flight controls, required visibility, emergency egress, or operation of aircraft systems.
Clips to the grab handles
Slides onto the front-seat grab handles. Nothing comes apart to fit it, it does not replace any original Cirrus hardware, and nothing is left behind when you remove it.
Doesn't block the view
Positioned to keep your outside sightlines clear, which is why it sits where it does rather than higher.
Heat-resistant print
Printed in the same heat-resistant filament as the rest of the range, rated above 210°F deflection — well past what a closed cockpit reaches on a hot ramp.
Tool-free, nothing comes apart
Questions
Send your model and generation and we'll confirm fit before you spend anything.
Not as designed — G7 and G7+ use a different grab handle. Ask us before ordering and we'll tell you where that stands.
No. It's positioned deliberately low to keep outside sightlines clear.
It slides onto the front-seat grab handles. No drilling, no cutting, no adhesive, no disassembly, and no permanent modification. It does not replace any original Cirrus hardware, and nothing is left behind when you take it off.
Two.
It's printed in the same heat-resistant filament as the rest of the range, rated above 210°F deflection.
This is a non-structural aftermarket accessory for mounting or storing portable equipment. Cirrus3DPrints does not represent it as an FAA-approved, FAA-certified, or OEM-approved aircraft component. As with any 3D-printed accessory, minor cosmetic variation in the print surface is normal. Whether its use is appropriate for a particular aircraft and operation is the responsibility of the aircraft owner/operator and pilot in command, in consultation with an appropriately qualified mechanic or other aviation professional when appropriate.
Aftermarket accessory. Cirrus3DPrints does not represent this product as an FAA-approved, FAA-certified, PMA-approved, STC-approved, TSO-approved, or OEM-approved aircraft component. Aircraft compatibility does not constitute approval by Cirrus Aircraft.
The aircraft owner/operator and pilot in command are responsible for determining suitability for their aircraft and operation, and for proper mounting, fitment, inspection, maintenance, and use.
Purchase and use are subject to our Terms of Sale & Product Use, including the full accessory disclaimer, assumption of risk, warranty disclaimers, and limitations of liability.
